Will these be a good setup?
Two of these: http://www.sonicelectronix.com/item_43777_Kenwood-KFC-W12PS.html - 250 rms/1000 Watt peak each
http://www.sonicelectronix.com/item_29611_Kenwood-KAC-8105D-Amplifier-Kit.html
And are these two boxes made out of the same stuff? There the same model and is one just a lower price then the other or is one made of better quality wood?
http://www.audiosavings.com/products/12-inch-Dual-enclosure/Atrend-E12D-Dual-12-Sealed-Car-Sub-Box-Enclosure,-1.25-Cubic-Feet,-3-4-MDF/E12D.aspx
http://www.abt.com/product/43307/Atrend-E12D.html
Also should this box be able to fit in a 2003 ford focus se sedan trunk?
Also since I will be wiring these to a mono amp at 2 ohms, and I have to run one sub +/- to the other sub and then that sub to the amp like this: http://m.seimg.net/product/img/subwoofer_wiring/2_subs_SVC_4_ohm_mono.jpg
What will be the easiest way to wire this in the box? Should I drill a hole in the middle piece of wood that separates the 2 subs and put the wire through that hole or should I make two holes in the back of the box and put the wires through there to be able to wire it at a 2ohms load?
Two of these: http://www.sonicelectronix.com/item_43777_Kenwood-KFC-W12PS.html - 250 rms/1000 Watt peak each
http://www.sonicelectronix.com/item_29611_Kenwood-KAC-8105D-Amplifier-Kit.html
And are these two boxes made out of the same stuff? There the same model and is one just a lower price then the other or is one made of better quality wood?
http://www.audiosavings.com/products/12-inch-Dual-enclosure/Atrend-E12D-Dual-12-Sealed-Car-Sub-Box-Enclosure,-1.25-Cubic-Feet,-3-4-MDF/E12D.aspx
http://www.abt.com/product/43307/Atrend-E12D.html
Also should this box be able to fit in a 2003 ford focus se sedan trunk?
Also since I will be wiring these to a mono amp at 2 ohms, and I have to run one sub +/- to the other sub and then that sub to the amp like this: http://m.seimg.net/product/img/subwoofer_wiring/2_subs_SVC_4_ohm_mono.jpg
What will be the easiest way to wire this in the box? Should I drill a hole in the middle piece of wood that separates the 2 subs and put the wire through that hole or should I make two holes in the back of the box and put the wires through there to be able to wire it at a 2ohms load?