Replacing pollen/Cabin filter on Nissan Micra K11 1999 Model

If equip with in cabin filter you access it Thur the glove box opening I just remove the glove box The filter either is on top of the blower unit or between the blower and Evaporator (A/C heat exchanger) and the heater box. Some time there are two tabs that say pull carefully pull upward on those tabs that releases the plastic rectangle shaped door. Remember the old filter has everything your allergic to stuck to it. Rubber gloves and particle mask might be needed. I just sneeze!

If you have aircon, then you have a pollen filter. It's behind the glovebox.
After removing the glovebox, you need to cut the panel behind to remove & replace the filter.

micra pollen filter-- fitted or not ??

i have a micra 1.4 se on a 52 plate with aircon and after cuting the dash behind the glove box and getting the conversion kit (metalbracket to replce section cut out ) i searched hih and low for a pollen filter /trap door then i got other mechs in our garage to search ,and i never ever found one, metal brkt fitted glove box replaced , SO the burning question is ,, are all the micra's with air con fitted with pollen filters or are the filters optional extras????????????

micra pollen filter-- fitted or not ??

Unregistered said:

i have a micra 1.4 se on a 52 plate with aircon and after cuting the dash behind the glove box and getting the conversion kit (metalbracket to replce section cut out ) i searched hih and low for a pollen filter /trap door then i got other mechs in our garage to search ,and i never ever found one, metal brkt fitted glove box replaced , SO the burning question is ,, are all the micra's with air con fitted with pollen filters or are the filters optional extras????????????

Click to expand...

Just in case there is still interest in this matter.....
Apparently, not all Micra's with A/C come with a pollen filter and unfortunately in such a case it can not (officially) be installed either.
I managed today to retrofit an original pollen filter in my 2002 Micra where there was NONE fitted ex-factory, although the car has the factory A/C fitted. Apart from cutting the dash behind the glove box I also had to cut a rectangular, vertical opening in the blower housing according to the dimensions of the plastic cover plate that I bought. This cover plate is held in place by a catch on the top side (had to make this), and a screw at the bottom - strangely enough the recess for the bottom clip nut was there.
Finally the pollen filter slid into place for the first time and the cover plate was installed - it comes with a foam seal glued onto it. In order to fit the screws that hold the metal bracket on the dash you need 3 pcs of a special push-in metal nut. All is available from Nissan.
It helps a lot to look in the parts manual in order to understand how the pollen filter version looks like, that's how I did it, with a little help of the local Nissan dealer.