How to i start the Tub Clean cycle in my LG washer?

[Unregistered]

I forgot to write in above post, that as soon as you turn off Spinsense, turn off the machine. Turn on the machine again, and press the Extra Rinse button for a few seconds to turn on TubClean, without setting the dial to any wash cycle. You can tell if it's working if the display says "tcl."

[Unregistered]

Turn Spinsense off

[Unregistered]

I just figured it out! Put bleach in the bleach dispenser. With the door open, press the tub clean button for 3 seconds. You shoud see "tcl" light up in the display. close the door and press the start button.

[Unregistered]

Last post I read said to turn off staincycle and it worked. Thanks

[Unregistered]

I have an LG WM2487HWMA Washer and had the tub clean problem. Holding the button for 3 seconds did nothing. Got the solution after reading this forum. This is what worked
"TubClean only works when Spinsense is turned OFF". Had to turn that off, and then everything worked fine.
Thanks Guys.

[Unregistered]

I tried to find the answer everywhere and nothing works but I find out and I want to share with you guys.

press the tub clean and after press turn the washer on. The display will show tub-clean message

[Unregistered]

THANK YOU SO MUCH to those of you who shared that the SpinSense must be deactivated before Tub Clean will work on my LG washer!!!!!! That saved me an expensive repair bill! LG shame on you for not putting this in your manual (and I read the WHOLE thing!)!!!!!!

[Unregistered]

I have a WM0642H LD machine. I pressed the tub clean for 3 seconds. It lights up to say "TCL". But the pre-wash button is lit up. The timer starts at "1 hr and ? (I forgot how many minutes). But when the count down starts, It gets stuck at 1 hr 13 minutes for like 3 hours.
Some people said to turn off the rinse-spin cycle; but since the light is off anyway, it should be considered "Off". I called the LG 1800 number, they had no clue either. What's the problem with LG????