1995 Acura integra 5sp problems?

Erica · Dec 8, 2008

I have a 95 acura integra 5sp and I was at a stop light and my all of a sudden the clutch peddle had no more pressure and I could not put it into gear, and I had to be towed home!! So my question is does anyone no what it could be? It has been sitting in my drive way foe 6wks and I hate being with out a car and I don't want to replace the whole clutch if it ant it!! Im hoping its the spring in the clutch or just stuck please some1 help me!!!!!

JustinM · Dec 8, 2008

Sounds to me like the hydraulic slave cylinder failed. Most cases where you have no pressure at the clutch pedal, has something to do with the lack of fluid reaching the slave cylinder or failed slave cylinder. Have you noticed any leaks under the car? Wet spots where you park. The slave cylinder is an inexpensive part that takes about 30 minutes to replace.

Nick · Dec 8, 2008

oooh i have a integra too,. sux though if its something that you havent had problems with before one of the links might of slipped, but unless you or someone has experience with trannys/clutch work you should just take it to a shop

Junior · Dec 8, 2008

Yes, hydraulic clutch linkage failed. Sometimes you can refill the clutch master cylinder with brake fluid(that's what it uses) and pump the clutch pedal a few times and it will go into gear. This master cylinder is very near the brake master cylinder and is smaller.

This is advice you need to remember if it ever happens again. It can save a tow bill and get you home. Still needs fixed,though.

DonR · Dec 8, 2008

It sounds like the clutch hydraulic cylinder has failed. Replace that and drive like new.

1995 Acura integra 5sp problems?

Erica

Member

JustinM

Member

Nick

Active member

Junior

Member

DonR

Member

Similar threads

Forum statistics

Share this page