Lte the Flash for Metro because, when they do it, they register the esn/imei so can work with them, cost $47
Step 1.
Remove your MicroSD card and plug the phone into your PC via USB cable then open QPST (QPST Configuration,
then go to Start Clients and select Service Programming) and then read the phone.
Once you read the phone, go to the m.ip tab and change from mobile ip to simple ip. Then look at the first
2 user profiles under m.ip open each one up and change the Nai to [email protected], for both
standard and tethered...
remove any ip address that you find in these 2 profiles. and remove any other profiles except the first 2.
also make sure both of them say enabled.
Now go to ppp config tab...
look at the tabs that say um and an... under these 2 tabs,, the user id should be
[email protected] tethered id should be the same,, password is metropcs in
lowercase on both tabs, remove any dns ip address you find in either tab also. just make
sure all ip address are blank.
once you are completed with this make sure you write to the phone and move on to the next step..
Step 2.
click on phone icon (on the phone)
click on the dialer..
enter ##3282#
click user name
click edit
enter your spc which should already be 000000 by now
Here are the settings:
User Name "[email protected]"
SPI MN-HA "1234"
SPI MN-AAA "1234"
M Home Address "000.000.000.000"
Prim Ha Ip "255.255.255.255"
Sec Ha Ip "255.255.255.255"
Rev Tunneling "Off"
AAA Password "metropcs"
HA Password "metropcs"
click done and allow the phone to reboot...
Step 3.
Step 3.
Now do ##3282# again.. this time go to browser
click edit
enter spc
youll see gateway1 and gateway2, under both of these
you will see primary and secondary,,, set primary and secondary ip`s for both gateways to 010.223.002.004,,
they will all be the same ip address,, and set the Port 3128 and secure Port 443 for all gatways to ,, hit done and reboot.
When you chose to open de browser comes a error, to fix that in Favorites open cnn o yahoo, y Listo.
Bookmarks