Hey everybody, I'm going to get my first car in about 7 months, by then, I'll have around 13000$. My question is, does an used (90k km) V6 3.5L chrysler 300 cost a lot on gas? And is it reliable?
Printable View
Hey everybody, I'm going to get my first car in about 7 months, by then, I'll have around 13000$. My question is, does an used (90k km) V6 3.5L chrysler 300 cost a lot on gas? And is it reliable?
From what I gather, the Chrysler 3.5L v6 isn't a terrible engine in terms of reliability, but it was way behind in power versus the competition. What you should expect for problems on that car are front end problems. You will need new wheel bearings, struts, ball joints etc around 100k most likely. The parts are cheap, and being RWD it takes half the time to install the parts too.
As for gas mileage, check fuelly.com. I see reports of 17-19 mpg and 23-24 mpg for v6 300s. They don't tell you which v6, and I will take a stab that most people reporting 23-24 probably do a bit of highway driving and have the 3.5l, based on how underpowered the 2.7L engine is.
The 2.7 liter engine is the same engine that Chrysler has been sued countless times for because they die an early death from sludge problems due to poor design. It's also incredibly underpowered. So the 3.5L or the 5.7L v8 (which gets 17/25 EPA and people claim that to be accurate from what I gather) would be the engine you want.
I test drove one with a 2.7 liter. I did not know about the engine woes at the time, but it was so underpowered I decided not to get it. But it was a very, very comfortable car.