kevinp

Dish network remote control #137180 need help on how to put codes into the remotes for TV, VCR and others.

Thanks

Unregistered

Press and hold the mode button for the device you want the
remote to control, for about three seconds. When all the other
mode buttons light up, let go of the mode button - that mode
button should now be flashing.
For example, hold the TV mode button for a TV until all of the
other mode buttons light. When you let go, the TV mode light
will flash.

Press the blank POWER button.

Press the up or down arrow button until
the device turns off. You will have to do this
repeatedly to scan through all codes.
Note: The mode button for the device will flash
rapidly eight times when you’ve scanned all the
codes for that device.

If the remote reaches the correct code, the device
turns off. When this happens, press the POUND (#)
button to store the code in the remote.

Press the blank POWER button to turn the
device back on.