Having a problem with my Audi A4. The CEL is on, and re-appears whenever I clear the codes. The code I am getting is P0112 (pd) - Air intake temperature sensor - circuit - low input. Any ideas on where to start? - is it the wire harness, the actual sensor?
Thanks!
My car is making whining noise, mostly when I turn the steering wheel. I was told to check the hydraulic fluid or the transmission fluid, but I don't know how. Any help would be great.
Its a 1997 Audi A4 Quattro 2.8L
Thanks.
I have a 2001 Audi A4 Quattro and i want to make it perform better.Ive heard of putting in an exhaust and a cold air intake. How much hp do you think this will add? What do you guys suggest? also if i did put an exhaust which do you recommend?
I am willing to spend about 1500 max.
OBDII Code: P0304 Cylinder 4 Misfire, P0171 System Too Lean - Bank 1, P0174 System Too Lean - Bank 2
What could cause these concurrent problems?
These are off the Autozone print offs for a Volkswagen, I'm trying to figure out what is causing these problems and if the code description is...
i heard that audi warranties last until 80k miles. after that ur on ur own. which leaves me to wonder if my 12 year old second hand audi is still under warranty. i still have the full maintenance record of the owner before me. they took good care of it with frequent maintenance. but now i need...
...v6 vs v8? i'm not looking for it to be super fast or powerful, but i do want a little more than the stock 2.8l, and i don't have the money to go about buying everything i'd need for the v8 swap. what would i need to put in a bigger v6? computer, exhaust, tranny, etc.? thanks
Problems: no fire from coil (Outside of distributor) and no fire to fuel pump
Questions:
What will not let the truck fire and not get gas from the tank?
Results: I have fire on the hot wire of the coil.
Question: Is there a pickup coil inside the distributor?
Nathan W- You asked Do I have...
Hi there.
I drive a 2000 VW Passat GLX, 2.8l V6 30valve, 5speed. I really enjoy it and it is pretty powerful at 190hp.
I am interested in forced induction for this engine. There is one supercharger kit out there for around $4000, but I would like to find more choice. Especially in the way...
solid Bad Brake Light Switch? The Brake Light was blinking and ABS was solid so I changed my front brake pads rotors and sensors. I noticed the front driver side sensor was cut so I had to rewire the sensor by hand.
After replacing these my brake light is blinking and ABS is solid. When I first...
Ive been looking at an 1986 s10 blazer with a 2.8L engine with 169k but a couple of people told me not to get it because the 2.8 is a junk motor.
is this true? and if yes, what usually goes wrong with them?